Electrical systems

What an ATS does—and what to check before connecting one to a generator

An automatic transfer switch (ATS) is intended to manage the transfer of selected electrical loads between a normal supply and a generator supply. It is a key part of many standby systems, but it is not a universal add-on: the switch, generator controls and site electrical design need to work together.

Understand the transfer sequence

In a typical arrangement, the system detects an abnormal normal supply, starts the generator and transfers the designated load when conditions are suitable. When the normal supply returns, the system transfers back according to its configured sequence. The exact logic depends on the equipment and design.

An ATS is not the same as a general-purpose switch that can be wired casually. It must be selected for the electrical system, the load and the generator interface, and installed with appropriate protection and isolation.

Check ratings and controls

A qualified designer should verify voltage, phase, current rating, short-circuit withstand, number of poles, neutral arrangement, source configuration and the way the generator receives a start signal. Confirm control wiring and communication compatibility with the specific generator controller.

Decide which circuits are transferred. Backing up a defined essential-load panel may be more practical than trying to transfer an entire facility. Motor starting, load sequencing and any sensitive equipment should be part of the design review.

Plan safe commissioning

Before commissioning, confirm drawings, cable routes, protection coordination, earthing, labelling and safe isolation. Test the operating sequence under controlled conditions, including generator start, transfer, return to normal supply and any intended load-shedding logic.

Do not attempt to install or test an ATS on an energised system. Electrical transfer equipment should be specified, installed and commissioned by appropriately qualified professionals under applicable local rules.

Explore ATS panel solutions

Contact NB Engineering